moOde

BlueZ Config

Select a command to submit to the Bluetooth controller. Turn on Bluetooth in Audio Config then select a command to submit to the Bluetooth controller.
1) Put your device in discovery mode and wait until it discovers Moode Bluetooth. You may have to turn Bluetooth off/on on your device to accomplish this.

2) To send audio from your device to moOde:
First turn on the Pairing agent in Audio Config and then initiate the connection on your device. Your device should automatically pair and connect. You can verify that your device has been successfully paired and connected by submitting "LIST paired" or "LIST connected" commands.

3) To send audio from moOde to your device:
First submit a "SCAN for devices" command and verify that your device appears in the scan results. The scan runs for 20 seconds. Next select the device in the dropdown list, PAIR it then select "MPD audio output->Bluetooth" from the dropdown then CONNECT.
Connect or remove a paired device.
NOTE: Connecting or Removing will automatically Change to the selected MPD audio output.
Disconnect the currently connected device.
NOTE: Disconnecting will automatically Change to the selected MPD audio output.
Select a device to pair with.
Send MPD audio output to the Local audio device or over a Bluetooth connection to another audio device. NOTE: Changing from Bluetooth output to Local output will automatically Disconnect the device.
Lower values result in less latency but may also cause dropouts on poor quality connections. Length of ALSA PCM output buffer in miliseconds.
Reconnect
Reconnect System restarted
Reconnect System shut down